Installing Rear Window Deflectors With Channel Clips

Your new WeatherTech Side Window Deflectors have been installed.

Installing rear window deflectors with channel clips. In-channel window deflectors are made with a thin flange that slots into a car doors upper window channel. When installed correctly the bottom edge of the front deflector. Your new WeatherTech Side Window Deflectors have been installed. If you have any further questions regarding Window Deflector installation please feel free to contact our dedicated and helpful Customer Service staff by calling 800-663-1570.

Slide the retention clip onto the outer window trim as shown. Remove and discard the plastic clip covers from the front and rear wind deflectors clips. For warranty information please visit. Insert the rear edge of the deflector into the window channel as shown.

Start Rear Window 11. Start by bowing the deflector slightly outward until youre able to fit the rear edge into the window channel. Whilst most side window deflectors are designed to clip into the window channel these ones are a little different. Contents 2 Front Side Window Deflectors 4 Channel Clips and 1 Tool included.

Let fresh air in while keeping rain snow and heat out. 26 SWG278 Pull down run channel gasket in the middle area of each window. This is WeatherTech Rear Side Window Deflectors with Channel Clip Installation Video by MacNeil Automotive Products on Vimeo the home for high quality. Attach any window clips if applicable.

If your wind deflector comes with any clips push them up between the deflector and the window to fasten it in place. Front with Channel Clips. 2 1 14-12 9 Carefully pull outward on the deflector. Contents 2 Front Side Window Deflectors 4 Channel Clips and 1 Tool included.

Bruceha_2000 Side Window Deflectors PriusChat and chrisspaulding weathertech window vents PriusChat have posted photos and a diagram in separate threads to show the way the clips supposed to workI would like to add two more detail points that helped me and wished. 8 Pull down and tuck in working from front to back. WeatherTech Window Deflectors httpsgooglrkBY7Z. Call customer service at 630-769-1500 Congratulations.

Pull tape backing approximately 1 25mm as shown. They are crafted from the finest 3mm acrylic material. These clips are notoriously difficult to put in. 6 Bow the deflector outward.

The channel clips should match the contour on the backside of the deflector. Next align the front edge of the deflector in line with the window channel. Your wind deflectors instructions should indicate where specifically to put the clips in. After the front edge is secure youll need to secure the opposite edge.

Installing these accessories is relatively simple but dont take the process for granted. Inspect deflector to ensure that it is fully inserted into the window channel. Next close your window fully and press firmly against weatherstripping from front to rear. They instead attach directly to the top of the door with no clips that go into the window channel.

WeatherTech Side Window Deflectors offer fresh air enjoyment with an original equipment look installing within the window channel. As you begin this installation lay out all the pieces and be certain that you have the correct deflector for each door drivers side front passenger side rear etc Start by lowering the window and tucking the flange all the way up into the window channel beginning at the front. 10 Be sure to remove adhesive backing before installation if supplied. Slide the front of the deflector upward until all the deflec-tors edges are fully seated into the window channel.

Also if you are in the market for new window deflectors be sure to review. One slight difference with this model comes with the installation method. Make sure to leave a small amount of space at the top of the deflector anywhere from ¼ to ½ gap. 2 Use the same tool to insert a channel clip.

Here is a video showing you how to install your WeatherTech Side Window DeflectorsWeatherTech Side. Then pull down the weather stripping in the first position which is approximately 8 from the rear of the deflector. 7 Insert the rear edge leaving a gap at the top. Insert the second channel clip as shown.

Installation is quick and easy with no exterior tape needed. Next close your window fully and press firmly against weather-strip from front to rear. Just installed the rear window deflectors with the factory supplied clips. The channel clips should match the contour on the backside of the deflector.

Some wind deflectors come with clips to adhere the wind deflectors edges in place. 1 Make sure that the window is clean and dry.

If you are searching for Installing Rear Window Deflectors With Channel Clips you've reached the right place. We have 15 images about installing rear window deflectors with channel clips including images, photos, pictures, wallpapers, and much more. In such page, we additionally provide variety of images available. Such as png, jpg, animated gifs, pic art, symbol, black and white, transparent, etc